Car amplifier supports soft start & Muting function
Four class AB high-current dual discrete drive stages
Class AB technology mosfet PWM power supply
Car amplifier supports overload, thermal, short circuit protection function
Bridgeable & Tri-mode operation
Subwoofer variable crossover for deep bass control
Gold plated RCA & power, speaker terminal
Power & protection indicator
Car amplifiers fuse rating: 40A x 1
Power output4 ohms, 4 channels driven:
- 85W x 4 or 170W x 2
- 250W x 4 or 500W x 2
Bridge Output4 OHM: 1000Watts
Signal Noise Ratio: > 100dB
Frequency Response: 10HZ - 40kHz (-1dB )
Input sensitivity: 100mV - 3V
Input impedance: 22K ohmvs
Speaker impedance: 4 ohms
High pass filter freq: 80HZ - 1.2KHZ
Low pass filter freq: 40HZ - 150HZ
Car amplifiers operation voltage (negative ground): DC 12V
Approved: CE / FCC
After Sales Service: 1 Year Warranty
Accessories:
1 x User Manual
Operational Guidance:
Never mount the car amplifier in a location that is subject to direct sunlight or exposed to moisture.
Never mount the car amplifier up side down, this will cause the heat to rise back into the amplifier causing thermal shutdown or possible permanent damage.
Be sure to mount the amplifiers to a strong, solid surface which will not give way under the stress of a sudden stop or accident.
Negative battery terminal must be disconnected before any electrical connection are made.
Be sure choose a location that provides substantial ventilation for the amplifier.
The location chosen should provide at leat 2? of clearance above the amplifier for adequate ventilation.
If the amplifier is to be mounted vertically be sure that it is in a place where adequate air will follow along the length of its heatsink fins for cooling.
Make sure that the mounting screws will not penetrate the gas tank, brake and fuel lines, wiring or other critical parts of your car when installed.