Security Fingerprint + Mechanical Key + Password 3 In 1 Lock

[EPC_SEC_404]

Reviews:[1]

American style, using international standard single latch
Independent designed clutch & special designed handle enhanced the durability of the lock
No keys to hide carry loss or forget
Elimination unwanted users in seconds
Add a new user in seconds
120 fingerprints memory capacity
3 access methods: Fingerprint, PIN code, and Mechanical key
No computer programming required
Warning beeps and red indicator light when battery is low
External 9V power input if battery is low
Stainless steel keypad. PVD coated surface enhanced the durability of the lock
Suitable for indoor doors, best substitute for knob locks
User can register your fingerprint direcly on the lock
Mechanical keys for emergency use
If you input the wrong password for three times, the buttons 1, 2, 3 will be locked. It will unlock automatically after three minutes or you can open the door using correct fingerprint
Working voltage: 6V
Fingerprint acquisition time: < 0.2 seconds
The using angle of finger: it can be discriminated correctly from free angle
This product provides several colors for selecting: Silvery and Dark Golden. Please write down your preferred choice at checkout.
Approved: CE / FCC
After sales service: 1 year warranty

Instructions of the lock buttons:
- Button "0": Door lock activation key; Setting passage mode
- Button "1": Enter setting status; Representing master fingerprint user group
- Button "2": Enter deletion mode; Representing general fingerprint user group
- Button "3": Enter PIN setting status; Representing temporary fingerprint user group
Assignment of fingerprint and PIN:
- Master fingerprint: Add / delete fingerprint, setup PIN, and general access. 10( quantity )
- Member fingerprint: General access. 90( quantity )
- Temporary fingerprint: General access. 20( quantity )
- PIN: General access. 1( quantity )
Initialization of the door lock:
- 1. Press on the battery cover button, slide the battery cover upward and remove it, you can see one hole at each side, and inside each hole there is a button for setup
- 2. Remove either of the four batteries, pressing the buttons on the front side to confirm the power is successfully cut off, then insert into the holes to press the buttons inside wih the two Hex wrenches supplied at the same time, hold it tight( not to release ), and reload the battery. The lock is then re-powered, if you hear a toot sound after 5 seconds, the initialization of the lock is successfully completed, and you may loose the two Hex wrenches.
- Note: After initialization of the lock, all the enrolled fingerprints and PIN in the lock are cleared, and any fingerprint can unlock the lock.