- It is made according to the principle of electrostatic belt for dangerous goods such as oil filling and gas filling, which effectively removes static electricity from the surface of the car.
- It can be adjusted in Long and short, and after the static belt is naturally worn, it can be lowered and used. (adjust bolt fixing plate)
- Copper wire grounding removes static electricity more efficiently. It effectively avoids the phenomenon that the other network and chain static belts are dirty by dust and then the static electricity is poor.
- Rubber is more wear-resistant and has a longer service life.
Method of use:
- Installed on the exhaust pipe at the rear of the car, first wipe the place where the exhaust pipe is in contact with the hoop to remove the rust.
- Put the clamp on the exhaust pipe (if the exhaust pipe with the tail throat is encountered, the clamp can be opened), the hook is hung on the clamp, and the screw is tightened (to ensure that the bottom of the rubber belt touches the ground.).
- If the bottom of the tape does not touch the ground or the rubber band becomes shorter after a period of use, open the adjustment plate to adjust the length so that the rubber band touches the ground.
- There is 2-3cm difference according to manual measurement. please check the measurement chart carefully before you buy the item.
- After the installation of the static belt, the bare copper wire at the bottom will be leveled within a few days. there is no need to worry about this. the rubber touches the ground, and the copper wire inside the rubber will introduce the static electricity.
- The copper wire is also shortened with the wear of the rubber. when the car is stopped and the rubber part is not in contact with the ground, the electrostatic tape needs to be replaced.
Product Weight : 105 G / 3.70 Ounces
Product Dimensions (L*W*H) : 375*85*60 MM / 14.76*3.35*2.36 Inches
Package Weight : 138 G / 4.87 Ounces
Package Dimensions (L*W*H) : 375*85*60 MM / 14.76*3.35*2.36 Inches