15CM Pneumatic extended engraving and grinding machine, grinding and polishing machine, grinding and polishing machine, sanding machine, wind grinding pen, tire repair rod

Pneumatic Extended Grinding Machine Working Pressure: 90psi (6.2Bar)
Idle speed: 20000rpm
Gas consumption: 4cfm
Weight: 0.70kg
Air intake interface: 1/4BSP
Pneumatic Extended Grinding Machine Product Usage:
-Suitable for various molds (shoe molds, tire molds, plastic shell switch molds, household appliance molds, etc.) and hardware product (faucets, zippers, hardware tools, and various complete equipment boxes, etc.)
-Polishing, grinding, grinding, chamfering, engraving, internal processing, rust removal, smoothing, polishing, welding point removal, blank trimming, and deburring of irregular parts such as curved surfaces, inner surfaces, gears, flat surfaces, inner holes, and grooves of objects.

Suggestions for using pneumatic tools for pneumatic extended engraving mills:
Please inject 2-3C before and after daily use C. # 60 Pneumatic Lubricating Oil (Clothing and Car Oil)
Please let it run freely for a few seconds after oil injection
Generally, in traditional air compressors, most of the compressed gas from the compressor contains moisture, as well as lubricating oil carried out by the compressor piston. If an oil-water separator is not used, water and oil will enter the pneumatic tool with the air, causing the wind blades to stick and the tool to move together, which may not be able to shake off the blades and may not start. If it can start, it will be insufficient torque. It is necessary to pay attention to injecting pneumatic oil from the rear inlet and then press the pneumatic tool to idle for a few seconds to restore normal torque