3D printer motherboard high-power hot bed module MOS tube power expansion

(Details are provided in both Chinese and English)

Description in Chinese:

3D printer motherboard high power hot bed module MOS tube power expansion large current load accessories

Description:
if your total power usage is 240W, And you have a 12V power supply, which means at least 20A(20x 12=240W). Since the controller board can only be set 1, This setting will not work. To make it work, you need this additional power module. This module can be used for Chitu motherboards and other open 3D printer motherboards. The module under normal cooling conditions, found that I(Max)= 2 when the working condition is stable, the use of current should not exceed 2. If you plan to use a heating bed and a 3D printer that uses a 12V power supply, it is recommended to use this module, otherwise it may cause excessive current and may burn out the connector on the controller board.

Features:
universal heating bed power extension module high power module for 3D printer.
Can be used on Chitu motherboards and other open 3D printer motherboards.
Help equip the controller board ( big 1) 3D printers have become more powerful. 2.
If you plan to use a heating bed and a 3D printer that uses a 12V power supply, it is recommended to use this module, otherwise it may cause excessive current and may burn out the connector on the controller board.

Product specifications:
color: Black
large current: 2 (enhanced heat dissipation)
package includes:
1 x hot bed extension power module (not including motherboard)
note:
1. Please allow 1-3mm error due to manual measurement. Thank you for your understanding.
2. The monitor is not calibrated, the color of the item shown in the photo may appear slightly different from the real object. Please use the standard.

English Description:

Product Description:

  Heated bed power module

Based on powerful MOSFET HA210NO6

Size: 60*50mm

Mounting holes: 3.2mm diameter, for M3 screws.

Distance betweeen holes: 54*43mm

Very powerful MOSFET to withstand higher current than normal RAMPS or other 3D Printer controller can handle

Voltage: 12V-24V

Maximum current with active cooling: 210A

This module is based on power MOSFET and will allow PID control of the heated bed (DC-DC Relays usually do not allow this)

Under the premise of normal cooling, it work stable under I (Max)=2, the current must not exceed 2 while the process working

1 x Heated Bed Power Module

1 x Connection cable for input signal

Picture show: