High performance buck-boost module low ripple band enable XL6009 DC-DC adjustable power supply

New product introduction:

1: Completely new XL6009/6019 chip, disassemble the chip.

2: imported patch electrolytic capacitor, by no means the domestic capacitor of the peer.

3: Up to 220Khz operating frequency, and LC filter circuit the output ripple is very low.

4: imported TDK-Inductors, reduce the heat and interference.

6: Input and output 3 MLCC Multilayer Ceramic Capacitors anti-interference improves stability.

7: PCB adoption kb sheet material, cardboard, garbage board.

8: Built-in MOSFET, say goodbye to LM2577 built-in triode, can reach 94% rate.

9: Added enable port, Can control whether the boost circuit works.

20W power module with enable port

size: 49 (long) * 23.4 (wide) * 11.4 (high) mm (without potentiometer)

module Parameters

module properties: non-isolated buck-boost module

input voltage: 5-32 V

output voltage:(1) Continuously adjustable (1.2-35V)

output current:1.5 A(MAX)

input current:4A (MAX)

output power: natural cooling20W, plus heat sink25W(MAX) actual power

output power = input voltage * 4A * conversion efficiency

output Ripple: input 12V output 24 0. Ripple 30MV20M bandwidth (for reference only)

operating temperature: industrial grade (-40 ℃ to +85 ℃)(the ambient temperature exceeds 40 ℃, please reduce the power or strengthen the heat dissipation)

full load temperature rise:45 ℃

operating frequency:220Khz

no-load current: typical 15mA(5V to 12V)

load adjustment rate:± 0.5%

voltage regulation rate: ±0.5 percent

dynamic response speed: 5% 200uS

enables control port: yes, high level 1.4V-VIN(ON), low level 0-0.8V(OFF), default high level

short circuit protection: none (please install fuse or protection circuit in input)

input reversed connection protection: no, please cooperate with us reversed connection protection plate or series diodes at the input.

Installation method: can be fixed by screws (fixing hole 3mm),2 fixing holes

wiring mode: soldering, plus pins can be directly soldered on the PCB