DC motor drive board 2-way motor drive module DRV8833 motor drive module small volume

Parameters:

size: 18.5*16mm

input voltage: 3-10V

single H-bridge output current: 1., can drive 2 DC geared motors.

Built-in overcurrent protection, short circuit protection, undervoltage lockout and overheat protection. Sleep mode with low power consumption.

Purpose: It can drive the following DC motors and 4-wire stepper motors.

Instructions for use:

ULT Low is sleep mode (requires disconnection of the J2 short solder joint on the back of the module)

OUT1 and 0UT2 are one H-bridge, and the corresponding control is IN1 and IN2.

OUT3 and OUT4 are the second H-bridge, and the corresponding control is IN3 and IN4.

EEP is the protection output and is not used by default.

VCC is the voltage input 3 to 10V.

GND to ground.