Double-head metal sheet cutter iron sheet cutter cutting saw power tool hardware cutter electric punching shear

Silver weight: 467g, orange weight: 352g, red weight: 360g

Product packaging: card packaging

Packing size: about 240*140*55mm;

Note: the silver host is all metal material; orange and red color part of the plastic material. Handle material is plastic.

1 the cutter head is frequently refueled, especially for cutting aluminum plates.
2 Open the electric drill first, then cut, exit first and then close the electric drill at the end.
3 When cutting, the incision of the cutter bar must be kept perpendicular to the workpiece to prevent hard bite from breaking the cutter head.
4 Replacement of the  bar: open the protective cover, take out the lock nut, loosen the set screw, pull out the  bar with pliers, reinstall the bar, and tighten the screw.
5 Replacement of  holder: Unscrew the compression cap counterclockwise and replace it with a new holder.

sheet hole opener instructions for use:
1 When a thin plate hole opener is used, first insert the front end of the electric drill and the cutter into the round hole of the hole opener to connect the cutter with the electric drill and lock it firmly, then tighten the three branches and stud screws on the shelf to prevent the hole opener shelf from sliding; Insert the ruler rod upward into the small square hole of the shelf with the left to right positioning needle, and finally adjust and tighten the top screw according to the size of the arc cut, fix the ruler firmly to ensure the accuracy of cutting round holes.
2 When cutting standard arcs, a thin plate hole opener should be used to keep the arc section smooth and beautiful. a 3mm positioning eye should be drilled first, then a 12mm hole should be drilled, and the cutter head should be inserted into the hole to cut the inner and outer circles.
Technical parameters:
1. There are two adjustable heads for cutting
2. The cutter head can be positioned 360 degrees in any direction
3. Electric or pneumatic drill, speed 1500-3000 r/min
4. Minimum cutting radius 12mm
allowable Cutting Thickness Reference
ordinary iron plate:≦0.8mm
stainless steel plate: not recommended
copper, aluminum plate:≦2mm
plastic plywood:≦2mm