Pulse high voltage package inverter 901 DC high voltage module arc generator 3-6V 800-1000KV

Size 26*88MM

this module for science small production with high voltage inverter, transformer / finished Booster Module

after inputting the DC3.7V-6V voltage at the input end, the DC high voltage of about tens of thousands of volts can be obtained at the output end.

It can be used as a high-voltage source for popular science experiments in middle schools, electronic instruments, negative ion generators, and small scientific productions.

The module is made by using the principle of T coil, outputting high-voltage pulse current, small size and high efficiency

the peripheral circuit is simple (just connect the switch, the battery can be) and the discharge intensity is fierce.

Note that this is not a high temperature arc, you can't light cigarettes and paper. 

Method of use

the module is divided into input terminal and output terminal. The red and green line is the input terminal, and the red and green lines are positive and negative, the output end is two high-voltage lines of the same color, and the input end is connected to the battery to generate a high-voltage arc.

Please operate the module in strict accordance with the method of use and precautions, otherwise it is easy to damage the module!

About input power: single section can be used 3.7V Li batteries or two in series, such as 18650 batteries, idle mobile phone batteries (to remove the protection plate, the recommended capacity is above 2000mAh) or nickel-cadmium/nickel-hydrogen battery packs, 4V or 6V lead-acid batteries, etc. (6V batteries can achieve good results)

attention

1, high-voltage module should avoid high-voltage no-load power-on use, before power-on to adjust the appropriate distance at the end of the high-voltage line, high-voltage line arc distance is proportional to the use of battery voltage and capacity.

2. When testing the arc distance, the short-to-long test shall be conducted. It is strictly prohibited to exceed the long arc distance when powering on. As high-voltage energy cannot be released, the module is easily damaged.

3. The power of the module is large, and it is not suitable for internal heat dissipation, so it cannot work for a long time. Generally, it is no problem within 10 seconds.

4. The way to judge whether the battery capacity can drive the output power is to measure the battery voltage when arcing. If in 6V about can output power.

5. Two small-capacity Li batteries are connected in series 7.2V, the measured voltage has dropped to about 4V in the arcing state, and the smaller the capacity, the lower the voltage. Therefore, it is recommended to use Li batteries above 2000MA, with good conditions to match batteries above 4000MA.